Sliprobot L1 User Manual download pdf (Page 13)

GRINDING THE DEPTH GAUGE LUGS

Set the grinding angle (o° degrees); see under Grinding angle.

Install the correct grinding wheel 1 (Fig G) for grinding the depth gauge

lugs (6 mm). Profile the grinding wheel so that it matches the lugs 2.

Adjust 3 back so that the grinding wheel 1 is aimed at the lug 2. (Apart from

this, perform the adjustment in the same way as when adjusting the grinding

of cutting links).

The incoming power must

always be switched off.

Check that the grinding wheel is not cracked and

that it is securely fixed to the spindle.

Stop the grinding wheel immediately if abnormal

vibrations occur.

Fig H

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Sliprobot L1 User Manual Page 13